
Our commitment is to satisfy you! Log in to view the stock in real time !
Vink cattle brush with dispenser
The Vink cattle brush with dispenser is a combination of a cattle brush and dose apparatus. There are nipples installed between the brush hairs, through which the liquid passes. When the animal is brushed the liquid will be applied on their skin. The animal will brush skin were it itches so the insecticide will reach the correct places. This apparatus can effectively be used against skin diseases and against flies. It is not advisable to force the animals to pass under the brushes at fixed times, the apparatus functions best when placed in a room where the animals can walk freely around and where it can be used by the animals when needed. The animals have to get used to the brushes before the reservoir is filled. One apparatus can be used for approx. 50 cows.
Placing in the stable
It is not advisable to force the animals to pass under the brushes at fixed times, the apparatus functions best when placed in a room where the animals can walk freely around and where it can be used by the animals when needed.
Placing in the field
The cattle brush with dispenser can best be placed nearby the watering place and be fixed to a pipe. You can also use a special plateau for in the field which enables it to move the cattle brush with dispenser with a tractor to another field.
Flies
Cows that are troubled by flies will use the brushes and in this way apply insecticide on their skins. The speed with which the liquid should pass is approx. 100 drops per minute.
Scabies
Drip speed approx. 60 drops per minute. Fill the reservoir again after 7 days for a second treatment and after 14 days for a third.
How to adjust the flow rate
Close the tap (11) by turning the brass screw to the right with a screwdriver. Push against one of the bleu nipples (12), now open the tap by turning the brass screw to the left so far as necessary to give the required drops.
Assemble the cattlebrush with dispenser
Put the parts side by side as shown in the drawing. Pass the tube through the hole in the middle of vertical part(B). Put both bolts (2) through the remaining holes. Fix horizontal part (C) to the vertical part (B) by fastening the nuts (3) as indicated in the drawing. Place the support of the container (4) against the container (5) Fasten the tube on the connecting piece on the container. Place support of container (4) and container (5) over the bolts (2) against vertical part Fasten the nuts (2). Put nipple unit (10) in the horizontal brushkeeper. Fix the tube to the tap (11), put the nipple unit into the horizontal part and screw on the protecting cap (9. If necessary measure the tube to the required length
Data sheet
Specific References
Product is available
Product is no longer in stock
Product is no in stock, but is allowed to be back-ordered